湖南长臂挖掘机出租,长沙长臂挖掘机出租
记住窍门挖掘机作业省油不是问题

文章来源:未知 文章作者:admin

第一点,当铲斗油缸和连杆、头杆油缸和头杆都成90°时,每个油缸推动挖掘机的力量最大。 加长臂挖掘机出租
First, when the bucket cylinder and the connecting rod, cylinder head and head rod are 90 degrees, each cylinder pushing force of excavator.
第二点,天然地面的挖掘,铲斗或松土器地板角保持在30°左右,收斗杆。斗杆接近垂直时,斗杆力最大,能更多地承载负荷。
Second, mining natural ground, bucket or Ripper floor angle is kept at about 30 degrees, close the bucket rod. The bucket rod close to the vertical, the maximum bucket rod force, more bearing load.
第三点,一开始挖掘时,不要把斗杆伸至最大作用范围,从80%左右开始效果最好。(斗杆最大作用范围时,斗杆挖掘力最小,挖掘难以进行)。这点一般新手多注意下。
Third, start digging, don't put the bucket rod extending to the maximum range, from around 80% had the best effect. (max. bucket scope, bucket rod force is difficult to carry out mining, mining). This general novice to pay more attention to the next.
第四点,斗杆挖掘范围:斗杆从远侧45°至内侧30°的角度。
Fourth, stick Mining: bucket rod from the distal 45 degrees to 30 degrees from the point of view.
因挖掘深度而稍有差异,但大致在该范围内操作大臂及铲斗,而不应该操作至油缸的行程末端。
Because of the depth of excavation is slightly different, but generally in the range of operating arm and bucket, and should not be the end of travel to the operating cylinder.
第五点,在进行连续挖掘时候,底盘置于前进方向上,在挖掘结束后可以立即行走。如果要走的的话再换,启动结束又要烧不少油。加长臂挖掘机出租:www.dyqicheng.com
Fifth, in the continuous mining, under the direction of the chassis, can walk in immediately after excavation. If you want to go and then change, start and end burn a lot of oil.
第六点,.在进行挖沟作业的时候,先挖掘沟槽的两侧,再挖掘中间部分。这样挖中间时能省不少事儿,还省劲。
Sixth., when trenching work, digging ditches on both sides of the first, then tap the middle part. So dig the middle can save a lot of things, but also save jin.长沙长臂挖掘机出租 www.hnsxwjj.com

上一篇:挖掘机挖斗的日常保养措施 下一篇:没有了